User's Manual

THE SETTINGS MODE

The console features a settings mode that allows you

to select a unit of measurement for the console and to

view console usage information.

To select the settings mode,

press and hold down the Watts

Workouts button until the settings

mode information appears in the

display.

The console can show pedaling speed and distance in

either miles or kilometers. The lower display will show

the selected unit of measurement. An E for English

miles or an M for metric kilometers will appear in the

display. To change the unit of measurement, press the

Resistance increase button repeatedly.

Note: When you replace the batteries, it may be neces-

sary to reselect the unit of measurement.

The center display will show the total distance (in miles

or kilometers) that the exercise bike has been pedaled

and the total time (in hours) that the console has been

used since the exercise bike was purchased. Press the

Calorie Workouts button repeatedly to view the total

distance and the total time.

To exit the settings mode, press the Watts Workouts

button.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to

computer or peripheral devices. Changes or modifications not expressly approved by the party respon-

sible for compliance could void the user’s authority to operate this equipment.