User's Manual

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest level, the drive

belt may need to be adjusted.

To a d just the dri ve b elt, you mus t rem ove the righ t

pedal, the right lock ring, and the right shield as

described below.

Using an adjust-

able wrench, turn

the Right Pedal (29)

counterclockwise

and remove it. Then,

using a standard (flat)

screwdriver, release

the tabs around the

edge of the right Lock

Ring (23), and then

remove it from the

Right Shield (22).

See assembly step 5 on page 8. Using a stan-

dard (flat) screwdriver, release the tabs along the

bottom edges of the Rear and Front Upright Covers

(19, 20), remove the two M4 x 12mm Screws (57), and

then remove the Rear and Front Upright Covers.

See the EXPLODED DRAWING on page 23.

Remove all of the screws from the Left and Right

Shields (21, 22); there are two sizes of screws in

the shields—note which size of screw you remove

from each hole. Then, gently remove the Right Shield.

Loosen the Adjustment Screw (47). Then, tighten the

Idler Screw (45) until the Drive Belt (59) is tight.

When the Drive Belt (59) is tight, tighten the

Adjustment Screw (47).

Then, reattach the left and right shields, the right lock

ring, and the right pedal.