User's Manual

3. Set a sturdy piece of packing material under the

Frame (1).

Orient the Front Stabilizer (2) as indicated by the

sticker. Attach the Front Stabilizer to the Frame

(1) with two M10 x 68mm Screws (44).

Remove the packing material.

4. Orient the Upright (4) as shown.

Tip: Avoid pinching the Main Wire (41). Attach

the Upright (4) to the Frame (1) with four M8 x

16mm Screws (60); start all the Screws, and

then tighten them.

Next, locate the wire tie in the Upright (4). Tie the

lower end of the wire tie to the Main Wire (41).

Then, pull the upper end of the wire tie until the

Main Wire is routed through the Upright.

Tip: To prevent the Main Wire (41) from fall-

ing into the Upright (4), secure the Main Wire

with the wire tie.

Insert the excess Main Wire (41) into the

Upright (4).

Avoid pinching the

Main Wire (41)

Wire Tie