User`s manual

Inspect and tighten all parts of the exercise cycle reg-

ularly. Replace any worn parts immediately.

To clean the exercise cycle, use a damp cloth and a

small amount of mild detergent. IMPORTANT: To

avoid damage to the console, keep liquids away

from the console and keep the console out of

direct sunlight.

CONSOLE TROUBLESHOOTING

If the console display becomes dim, the batteries

should be replaced; most console problems are the

result of low batteries. To replace the batteries, see

assembly step 5 on page 8. If the handgrip pulse sen-

sor does not function properly, see step 5 on page 15.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, the left pedal and the left shield must be

removed.

Using an adjustable wrench, turn the left pedal clock-

wise and remove it. Next, remove all of the screws

from both shields; there are two sizes of screws in

the shields—note which size of screw you remove

from each hole. Then, carefully remove the left shield.

Locate the Reed Switch (39). Turn the Left Crank Arm

(66) until a Magnet (38) is aligned with the Reed

Switch. Loosen, but do not remove, the M5 x 15mm

Screw (47). Slide the Reed Switch slightly closer to or

away from the Magnet, and then retighten the Screw.

Turn the Left Crank Arm for a moment. Repeat until

the console displays correct feedback.

When the Reed Switch is correctly adjusted, reattach

the shields and the left pedal.

MAINTENANCE AND TROUBLESHOOTING