User`s manual

HOW TO ADJUST THE BELT

If you can feel the pedals slip while you are pedaling,

ven when the resistance is at the highest level, the

belt may need to be adjusted. To adjust the belt, the

edals and the shields must be removed.

Use an adjustable wrench to remove the pedals. To

remove the left pedal, turn the left pedal clockwise; to

remove the right pedal, turn the right pedal counter-

clockwise.

Next, remove all of the screws from both shields; there

are two sizes of screws in the shields—note which

size of screw you remove from each hole. Then,

carefully remove the shields.

Next, loosen the 3/8" Nuts (27), which are located on

each side of the Flywheel (37). Then, tighten the M6

Locknuts (32), one on each side of the Flywheel, until

he Belt (35) is properly tightened.

Finally, tighten the 3/8" Nuts (27) and reattach the

shields and the pedals.