User`s manual

7
3
3. While another person holds the Upright (13)
near the Frame (1), connect the Upper Wire
Harness (23) to the Lower Wire Harness (68).
Insert the excess wire downward into the Frame
(
1).
Tip: Avoid pinching the wires. Insert the
Upright (13) into the Frame (1). Attach the
Upright with three M8 x 16mm Patch Screws
(34) and three M8 Split Washers (42).
Avoid pinching
the wires
42
34
23
13
1
34
4
4. While another person holds the Handlebar (50)
near the Upright (13), insert the Pulse Wires
(59) into the Upright and pull them upward out
of the top of the Upright.
Tip: Avoid pinching the wires. Attach the
Handlebar (50) to the Upright (13) with the Pivot
Clamp (54), the Rear Cover (3), and the Pivot
Handle (55).
Note: The Pivot Handle (55) functions like a
ratchet. Turn the Pivot Handle clockwise, pull it
away from the Upright (13), turn it counterclock-
wise, push it toward the Upright, and then turn it
clockwise again. Repeat this process until the
Pivot Handle is tight.
Attach the Rear Cover (3) to the Upright (13)
with an M4 x 15mm Screw (48).
Avoid pinching
the wires
3
13
23
54