User Manual Treadmill PFTL39190

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and

follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-

free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

1. SYMPTOM: THE POWER DOES NOT TURN ON

a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into

a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) Use only a UL-listed

surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. See step

1 on page 9.

c. Check the circuit breaker located on the treadmill near the

power cord. If the switch protrudes as shown, the circuit

breaker has tripped. To reset the circuit breaker, wait for five

minutes and then press the switch back in.

2. SYMPTOM: THE POWER TURNS OFF DURING USE

a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit

breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console. See step 1 on page 9.

d. If the treadmill still will not run, please call our Customer Service Department, toll-free.

3. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY

a. Check the batteries in the console. See BATTERY INSTALLATION on page 8. Most problems are the result

of drained batteries.

b. Remove the key from the console and UNPLUG THE POWER

CORD. Remove the screws from the hood. Carefully remove the

hood. Locate the Reed Switch (44) and the Magnet (45) on the

left side of the Pulley (50). Turn the Pulley until the Magnet is

aligned with the Reed Switch. Make sure that the gap between

the Magnet and the Reed Switch is about 1/8”. If necessary,

loosen the Screw (33) and move the Reed Switch slightly.

Retighten the Screw. Re-attach the hood, and run the treadmill

for a few minutes to check for a correct speed reading.

Tripped

Reset

Tripped

Reset

Top

View

1/8”