User`s manual

_4-JaserLaJ_andraiLExtensicn(85)Jnto_heJeft_oskas_
shown.AligntheholesintheHandrailExtensionwiththe
holesinthepost.Ifnecessary,taptheHandrail
Extensionwitharubbermallettofullyinsertit.Next,attach
theHandrailExtensionbytighteningthreeSmallScrews
(76)intotheindicatedholes.Note:IfthereIsonlyone
holein thetop of thepost,tightenthethirdSmall
Serewintothe holein theleftsideofthepest,
IdentifytheLeft Foam Gnp (110), which has a large
cutout in the right side. Slide the Left Foam Grip as far as
possible onto the post on the left Updght (82). It may be
helpful to apply soapy water to the Handrail Extension (85).
Cutout
\
110
85
Post
76._
5. Make sure that the front edge of the Left Foam Gdp (110)
is under the Console Base (87) as shown. Tighten a
Small Screw (76) into the side of the Left Foam Gdp as
shown. Note: You may need to pull out on the side of the
Foam Grip to align the Small Screw with the hole in the
Upright (82).
Attach the Right Foam Grip (net shown) and the other
Handrail Extension (not shown) as described in step 4
end this step.
Note: Extra screws may be included.
6. Refer te drawing 6a. Lecate the left Rear Foot (59) on
the treadmill, if the left Rear Foot touches the floor, go to
step 7. If there is a space between the left Rear Foot and
the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page
20.
Refer te drawing 6b. Using a phillips screwdriver,remove
the Screw (60), the right Rear Foot (59), and the Rear
Foot Spacer (11) from the treadmill. Reattach the right
Rear Foot without the Rear Foot Sl_aoer. Hold the tread-
mill witb both hands and, lower the'treadmill as
described on page 21.
Check the left Rear Foot (59 [see drawing 6a]). If the left
Rear Foot is still off the floor, raise the treadmill and re-
move the left Rear Foot. Snap the Rear Foot Spacer (11)
onto the left Rear Foot and reattach the left Rear Foot
and the Rear Foot Spacer. Carefully lower the treadmill.
6a
87
76---_..
59
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet
from damage, place a mat under the treadmill.
7