User`s manual

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is adjusted to the highest

level, the drive belt may need to be adjusted.

To adjust the drive belt, you must remove the right

pedal, the shield cover, and the right frame shield (see

the instructions below).

Using an adjustable wrench, turn the right pedal coun-

terclockwise and remove it.

See HOW TO ADJUST THE REED SWITCH on page

18 and remove the Shield Cover (12).

Next, see the EXPLODED DRAWING near the end of

this manual and remove the M4 x 16mm Screws (61)

from the Right and Left Frame Shields (38, 39). Then,

gently remove the Right Frame Shield.

Hold the two M8 Locknuts (67) and loosen the two

M8 x 16mm Flat Head Screws (73). Next, loosen the

M10 x 35mm Hex Screw (74) until the Drive Belt (77) is

tight. Then, hold the M8 Locknuts and tighten the M8 x

16mm Flat Head Screws.

Then, reattach the right frame shield, the top shield,

and the right pedal.