Patent Pending Model No. 831.285732 Serial No. Write the serial number in the space above for future reference. Serial Number Decal CAUTION Read all precautions and instructions in this manual before using this equipment. Keep this manual for future reference. USER'S MANUAL SEARS, ROEBUCK AND CO.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 PART IDENTIFICATION CHART . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read the following important precautions before using the PROFORM¨ 485E. 8. Wear appropriate clothing when using the 485E. Always wear athletic shoes for foot protection. 1. Read all instructions in this manual before using the 485E. 2. Use the 485E only as described in this manual. 9. When mounting and dismounting the 485E, always hold the handlebars or the T-handle and step onto and off the pedal that is in the lowest position. 3.
BEFORE YOU BEGIN Congratulations for selecting the PROFORM¨ 485E low-impact elliptical exerciser. The 485E is an incredibly smooth exerciser that moves your feet in a natural elliptical path, minimizing the impact on your knees and ankles. And the unique 485E features adjustable resistance, upper-body and stationary handlebars, and a multi-mode exercise monitor to help you get the most from your exercise. Welcome to a whole new world of natural, elliptical-motion exercise from PROFORM.
PART IDENTIFICATION CHART Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part is the key number of the part, from the PART LIST on page 14. The number after the dash indicates the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.
ASSEMBLY Assembly requires two people. Place all parts of the PROFORM¨ 485E in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires a phillips screwdriver mallet . , two adjustable wrenches 1. Feed the console wire down through the Upright (3) as shown. While another person holds the Upright near the Frame (1), tie the console wire and the Sensor Wire (25) together as shown in drawing 1a.
3. Attach a Pedal (31) to one of the Pedal Arms (12) with three #8 x 3/4Ó Round Head Screws (16) as shown. 3 31 Repeat this step to attach a Pedal to the other Pedal Arm (not shown). 12 16 4. Make sure that there are Pedal Arm Bushings (42) in the ends of both Pedal Arms (12). 4 9 Identify the Left Handlebar (8) (there is a decal on the Left Handlebar for identification).
6. Refer to drawing 6a. Push the left Pedal Arm (12) until the axle on the left Pulley Arm (34) is at the back of the Side Shields (4, 5) as shown. 6 Slide a Weld Spacer (49) and a Pivot Bushing (45) onto the left axle on the Upright (3). Make sure that the open side of the Weld Spacer is facing the Upright and that the Pivot Bushing is turned as shown. Slide the Left Handlebar (8) onto the left axle on the Upright (3). Make sure that the Left Handlebar slides onto the Pivot Bushing (45) on the axle.
HOW TO USE THE PROFORM¨ 485E HOW TO EXERCISE ON THE 485E HOW TO ADJUST THE RESISTANCE OF THE PEDALS To mount the 485E, firmly hold the handlebars or the T-handle and carefully step onto the pedal that is in the lowest position. Next, step onto the other pedal. Push the pedals until they begin to move with a continuous motion.
DESCRIPTION OF THE CONSOLE HOW TO OPERATE THE CONSOLE The console is designed to help you get the most from your workouts. As you exercise, you can watch your progress around the LED track, while the display provides continuous exercise feedback. The six modes of the display are described below. If there is a thin sheet of clear plastic on the face of the console, remove it. 1. To turn on the power, press the on/reset button or simply begin exercising.
MAINTENANCE Inspect and tighten all parts of the PROFORM¨ 485E regularly. Replace any worn parts immediately. CONSOLE TROUBLE-SHOOTING If the console does not function properly, the batteries should be replaced. To replace the batteries, refer to assembly step 8 on page 8. The 485E can be wiped clean with a soft cloth and mild detergent. Do not use abrasives or solvents. To prevent damage to the console, keep liquids away from the console. Use only a sealable water bottle in the console.
CONDITIONING GUIDELINES The following guidelines will help you to plan your exercise program. Remember that proper nutrition and adequate rest are essential for successful results. uses easily accessible carbohydrate calories for energy. Only after the first few minutes of exercise does your body begin to use stored fat calories for energy. If your goal is to burn fat, adjust the intensity of your exercise until your heart rate is near the smallest number in your training zone as you exercise.
Training zone exercise, consisting of 20 to 30 minutes of exercising with your heart rate in your training zone. (During the first few weeks of your exercise program, do not keep your heart rate in your training zone for longer than 20 minutes.) EXERCISE FREQUENCY To maintain or improve your condition, plan three workouts each week, with at least one day of rest between workouts. After a few months of regular exercise, you may plan up to five workouts each week, if desired.
PART LISTÑModel No. 831.285732 Key No. Part No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 NSP 143334 142799 143335 143336 141103 142058 143655 143656 143130 013163 143339 013316 143340 143341 013322 012090 100128 104536 119425 143342 143344 143345 107094 143346 143363 109204 143361 012108 143348 141779 Qty.
EXPLODED DRAWINGÑModel No. 831.
The model number and serial number of your PROFORM¨ 485E are listed on a decal attached to the frame. See the front cover of this manual to find the location of the decal. Model No. 831.285732 If you find that: All replacement parts are available for immediate purchase or special order when you visit your nearest SEARS Service Center. To request service or to order parts by telephone, call the toll-free numbers listed at the left.