User`s manual

13
HOW TO ADJUST THE PEDAL STRAPS
To tighten the pedal straps (see the drawing on page
4
), simply pull the ends of the pedal straps. To loosen
the pedal straps, press and hold the tabs on the buck-
l
es, adjust the pedal straps to the desired position,
and then release the tabs.
HOW TO ADJUST THE PEDALING RESISTANCE
To increase the
resistance of the
pedals, turn the
resistance knob
clockwise; to
decrease the resis-
tance, turn the
resistance knob
counterclockwise.
To stop the flywheel, push the brake lever down-
ward. The flywheel should quickly come to a
complete stop.
IMPORTANT: When the exercise bike is not in use,
tighten the resistance knob completely.
HOW TO LEVEL THE EXERCISE BIKE
If the exercise bike rocks slightly on your floor during
u
se, turn one or both of the leveling feet on the front
or rear stabilizer (see the drawing on page 4) until the
r
ocking motion is eliminated.
HOW TO MAINTAIN THE EXERCISE BIKE
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, see the drawing in assembly step 14 on page
11.
Rotate the flywheel until the magnet is aligned with the
reed switch. Slide the reed switch slightly toward or
away from the magnet. Then, rotate the flywheel for a
moment. Repeat these actions until the console dis-
plays correct feedback.
Resistance
Knob
Brake
Lever