User`s manual

8. Route the Upright Wire (69) through one of the
Handrails (40). Attach the Handrail to the Right
Upright (39) with two Handrail Bolts (9) and two
Handrail Star Washers (11). Do not pinch the
Upright Wire.
Attach the other Handrail (40) to the Left Upright
(38) with two Handrail Bolts (9) and two Handrail
Star Washers (11). Firmly tighten the Handrail
Bolts.
Cut the plastic tie and remove the strap from the
Upright Wire (69).
39
38
69
9
11
40
9
11
40
8
7. Pull the indicated strap until the Upright Wire
(69) is extending from the upper end of the Right
U
pright (39).
S
lide the Right and Left Base Leg Covers (42,
33) onto the Left and Right Uprights (38, 39).
Starting at the front of the Base Leg Cover,
press them down onto the Base (37) as shown. If
necessary, pry lightly on the sides of the Base
Leg Covers to fit them over the Wheel Nuts (90)
and Bolts (5).
39
38
Front
42
37
5
90
33
7
69
Strap
69
40
9. Have another person hold the Console Base
(67) near the right Handrail (40). Attach the
ground wire on the Console Base to the right
Handrail (40) with a Silver Ground Screw (10).
Connect the wire harness on the Console Base
(67) to the Upright Wire (69) as shown in the
inset drawing. Important: If the connectors are
oriented correctly, they will slide together
easily and snap into place. If the connectors
are not oriented correctly, the console may
be damaged when the power is turned on.
Insert the connectors and excess wire into the
Console Base (67).
10
67
Ground
Wire
69
Wire
Harness
9
9