User`s manual

Dudng heart rate pro-
grams, the program
display will show a
graphic that represents
your heart rate. Each
time a heartbeat is de-
tected, an additional
peak willappear.
DO@O000
DO00000
I@0@0@@
B Enter your age.
When a head rate pro-
HEART RATE •
gram is selected, the let- ,_-_
ters AGE and the current _1 L_ LJ___ L-- J
age settingwillbegin to _'ArCALS.CALS.
flash in the Calories/
Fat Calories/Heart Rate
display. You must enter your age to use a heart
rate program. If you have already entered your
age, go to step 5. If you have not entered your
age, press the Incline (Age Set) buttons until your
age is shown. Your age will then be saved in mem-
o_.
_'_ Adjust the maximum speed limit for the
program.
When a heart rate pro-
gram is selected, the let-
ters SPd (speed) and the
maximum speed limit for
the program willflash in
the Speed/Min-MUe dis-
KrnlH
[ -g
SPEED MIN/MILE{Io_)."
play. Ifdesired, change the maximum speed limit
by pressing the Quick Speed buttons.
r_ Press the Start button or the Speed A button to
start the program.
A moment after the button is pressed, the tread-
millwill automatically adjust to the first speed and
incline settingsfor the program. Hold the handrails
and begin walking.
Each heart rate program is divided into one-minute
segments. (The Time/Incline/Segment Time dis-
play wiltshow both the time remaining in the pro-
gram and the time remaining in the current seg-
ment of the program.) One target heart rate set-
ting is programmed for each segment. (The same
target heart rate settingmay be programmed for
consecutive segments.)
Dudng the program, the console willregulady
compare your heart rate to the current target heart
rate setting. If your heart rate is too far below or
above the target heart rate setting, the speed of
the treadmill willautomatically increase or de-
crease to bring your heart rate closerto the target
heart rate setting. If the speed reaches the maxi-
mum speed limit for the program (see step 6 at
the left) and your heart rate is still too far below
the current target heart rate setting, the incline of
the treadmill will also increase to bring your heart
rate closer to the target heart rate setting.
The program willcontinue until no time remains in
the program. The walking belt willthen slow to a
stop.
If the speed or inclinesetting istoo high or too
low, you can adjust the setting with the speed or
incline buttons. However, each time the console
compares your heart rate to the current target
heart rate setting, the speed and/or incline of the
treadmill may automat'realLychange to bdng your
heart rate closer to the target heart rate setting.
If your pulse isnot detected dudng the program,
the letters PLS will flash in the Calories/Fat
Calories/Heart Rate display and the speed and in-
cline of the treadmill may automatically decrease
until your pulse is detected. If this occurs,see the
instructions included with the chest pulse sensor.
To stop the program at any time, press the Stop
button. Heart rate programs should not be stopped
temporarily and then restarted. To use a heart rate
program again, reselect the program and start it at
the beginning.
B Follow your progress with the displays.
See step 5 on page 10.
r_ When the program is completed, remove the
key from the console.
See step 6 on page 13.
14