USER'S MANUAL Home Gym

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , two adjustable wrenches wire cut-

ters , and a rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal

condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off

the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the

Uprights (11) until the treadmill is in the position shown.

2a.Check to see if the Wheels (37) are attached to the

Extension Legs (34). If the Wheels are attached, go to

step 2b. If they are not attached, attach a Wheel to each

Extension Leg with a Wheel Bolt (36) and a Wheel Nut

(22) as shown. Tighten the Wheel Bolts only until

they are snug; do not overtighten them.

2b.Insert one of the Extension Legs (34) into the treadmill

as shown. Make sure that the Base Pad (40) is on the

indicated side. Note: It may be helpful to tip the Uprights

(11) in the direction shown by the arrow as you insert

the Extension Leg. To fully insert the Extension Leg, it

may be necessary to tap it with a mallet.

Attach the Extension Leg (34) with an Extension Leg

Screw (53). Note: If there are short and long Extension

Leg Screws, use the long Screw. Make sure to push

on the head of the Screw while tightening it.

Attach the other Extension Leg (34) in the same way.

Extension Leg

Screw (53)–2

Screw (33)–6

Handrail Washer (92)–2

Handrail Nut (47)–2

Rack Bolt (89)–2

Rack Washer

(41)–2

Handrail Bolt (91)–2

Wheel Nut (22)–2

Wheel Bolt (36)–2