USER'S MANUAL Home Gym

DIAGRAM OF THE CONSOLE

Clip

Key

Speed Control

Displays

Incline Control

PulseSensor

CAUTION:Before operating the

console, read the following precautions.

• Do not stand on the walking belt when turning

on the power.

• Always wear the clip (see the drawing above)

while using the treadmill. When the key is re-

moved from the console, the walking belt will

stop.

• Adjust the speed in small increments.

• The training zones marked beside the speed

control are general guidelines only. See page

14 for more information.

• To reduce the possibility of electric shock,

keep the console dry. Avoid spilling liquids on

the console. Use only a sealable water bottle.

BATTERY INSTALLATION

The console requires three "AA" batteries (not in-

cluded). Alkaline batteries are recommended. To in-

stall batteries, open the battery cover as shown below.

Press the batteries into the battery compartment, with

the negative (–) ends of the batteries touching the

springs. Close the battery cover, push up on the tab,

and then push the tab forward as shown. Be sure that

the tab locks into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the

power cord is properly plugged in. (See HOW TO

PLUG IN THE POWER CORD on page 7.)

Next, step onto the foot rails of the treadmill. Find the

clip attached to the key (see the drawing above), and

slide the clip onto the waistband of your clothing. Test

the clip by carefully taking a few steps backward

until the key is pulled from the console. If the key

is not pulled from the console, adjust the position

of the clip as needed.

Follow the steps on page 9 to operate the console.

Battery

Cover Tab

Batteries

Battery Cover