Owner's Manual

If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the

receiver included with the chest pulse sensor.

2. Connect the Long Jumper Wire (A) to the PULSE #1 jack

on the back of the Console (42) (refer to the inset draw-

ing). Connect the other end of the Long Jumper Wire to

the wire on the Receiver (B). Next, peel the paper off the

pad on the back of the Receiver. Turn the Receiver so

the cylinder is on the side shown, and press the

Receiver onto the back of the Console Base (38) in the

indicated location. Note: Any remaining wires can be dis-

carded. The wire tie can be used to tie wires if needed.

Make sure that no wires are pinched. Refer to step 1

above and reattach the Console Back (40).

Screws

PULSE #1

PULSE Jack

1. MAKE SURE THAT THE POWER CORD IS UN-

PLUGGED. Remove the screws from the Console Back

(40). If the screws are different lengths, make sure to

note where each type of screw is used. Remove the

Console Back from the Console Base (38).

Cylinder