User`s manual

9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip-

tical exerciser.

8. Identify the Left Rear Spring Bracket (12) on the left

Pedal Spring (11). Apply a small amount of grease

nside the Pedal Arm Bushings (37) in the Left Rear

Spring Bracket and to the axle on the left Disc

rossbar (16). Slide a Spring Spacer (63) onto the

axle; make sure that the Spring Spacer is turned

so the flat side is facing the elliptical exerciser.

Next, slide the Left Rear Spring Bracket onto the axle.

Slide a Spring Bracket Washer (35) onto an M10 x

27mm Patch Screw (40), and tighten the Patch Screw

into the axle.

Next, hold the lower end of the left Handlebar Leg (5)

inside the Front Spring Bracket (76) on the left Pedal

Spring (11). Apply grease to an M10 Bolt Set (74).

Attach the Handlebar Leg to the Front Spring Bracket

with the Bolt Set.

Do not overtighten the Bolt Set;

the Handlebar Leg must pivot freely.

Attach the right Pedal Spring (not shown) to the

right side of the elliptical exerciser in the same

way.

See step 7. Tighten the M8 x 45mm Button Bolts

(50).

Grease