Owner's Manual

20. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley

(27) in the direction shown. Attach the ÒVÓ-Pulley and

a Large Cable Trap (32) to the bracket on the back

of the Butterfly Upright (1) with a 3/8Ó x 2 1/2Ó Bolt

(53) and a 3/8Ó Nylon Locknut (50). Make sure that

the Large Cable Trap is oriented as shown.

19. Locate and open the parts bag labeled ÒCable

Assembly and Pulleys.Ó For Cable identification

and routing during steps 19 to 49, refer to the

Cable Diagram and Cable ID Chart on page 23 and

24.

Identify the Butterfly Cable (73); it is approximately

65Ó long and it has a closed loop on each end. Attach

one end of the Butterfly Cable to the bracket on the

Left Butterfly Arm (10) with a 3/8Ó x 1Ó Bolt (84) and

two 3/8Ó Nylon Jam Nuts (63). Note: The loop on the

Cable and the two Nylon Jam Nuts must be

underneath the bracket.

Bracket

Cable Assembly

22. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley

(27) in the direction shown. Attach the ÒVÓ-Pulley and

a Large Cable Trap (32) to the welded bracket (see

the inset drawing) on the back of the Butterfly

Upright (1) with a 3/8Ó x 2 1/2Ó Bolt (53) and a 3/8Ó

Nylon Locknut (50). Make sure that the Large Cable

Trap is oriented as shown.

Welded

bracket

21. Remove both 3 1/2Ó Pulleys (24) and the Cable Trap

(25) from the pre-assembled Pulley Plates (23).

Wrap the Butterfly Cable (73) around a 3 1/2Ó Pulley

(24) in the direction shown. Attach the Pulley and the

Cable Trap (25) to the top hole in the Pulley Plates

(23) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon

Locknut (50). Make sure the Cable Trap and Pulley

Plates are oriented as shown in the drawing.

Welded

bracket