Owner's Manual

23. Attach the Butterfly Cable (73) to the bracket on the

Right Butterfly Arm (11) with a 3/8Ó x 1Ó Bolt (84) and

two 3/8Ó Nylon Jam Nuts (63). Note: The loop on the

Cable and the two Nylon Jam Nuts must be

underneath the bracket.

Bracket

24. Identify the Weight Cable (72); it is approximately

117 3/4Ó long and it has a closed loop on one end

and a bolt on the other end.

Attach the closed loop on the Weight Cable (72) to

the indicated bracket on the Weight Top Frame (66)

with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut

(50).

26. Wrap the Weight Cable (72) around a 3 1/2Ó Pulley

(24) in the direction shown and route it down through

the bracket on the Weight Top Frame (66). Attach the

Pulley inside the bracket on the Weight Top Frame

with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut

(50).

25. Remove both 3 1/2Ó Pulleys (24) from the pre-assem-

bled Pulley Bracket (22).

Wrap the Weight Cable (72) around a 3 1/2Ó Pulley

(24) in the direction shown. Attach the Pulley and a

Cable Trap (25) to the indicated hole of the Pulley

Bracket (22) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó

Nylon Locknut (50). Make sure that the Pulley

Bracket and Cable Trap are oriented exactly as

shown.

Route the Weight Cable (72) up through the bracket

on the Weight Top Frame (66) from below.