Owner's Manual

27. Attach the bolt at the end of the Weight Cable (72),

the 1/2Ó Plain Nut (107), the 1/2Ó Flat Washer (86),

and the Long Weight Spacer (98) to the Weight Tube

(17) in the order shown.

Note: The bolt at the end of the Weight Cable (72)

is one of the means for tightening the Cables (72,

73, 74, and 75). After you have mounted all four

Cables, use the following procedure for tightening

the Cables: Thread the bolt into the Weight Tube

(17) until all Cables are tight and rest firmly in the

grooves of all Pulleys. Then tighten the 1/2Ó Plain

Nut (107) onto the 1/2Ó Washer (86).

Bolt

107

29. Wrap the High Cable (74) around a 3 1/2Ó Pulley (24)

in the direction shown. Attach the Pulley and a Cable

Trap (25) to the indicated hole in the Press Upright

(2) with a 3/8Ó x 4 3/4Ó Bolt (60) and a 3/8Ó Nylon Jam

Nut (63). Note: Thread the Jam Nut only two turns

onto the Bolt. You will attach another Pulley to the

Bolt in step 31.

28. Identify the High Cable (74); it is approximately 98Ó

long and it has a ball on each end.

Wrap one end of the High Cable (74) around a 3 1/2Ó

Pulley (24) in the direction shown. Attach the Pulley

to the indicated hole in the Press Top Frame (9) with

a 3/8Ó x 3 1/2Ó Bolt (56), a 3/8Ó Flat Washer (48), and

a 3/8Ó Nylon Jam Nut (63). Make sure that the Cable

is between the Pulley and the lat bar holder.

Lat Bar

Holder