Owner's Manual

30. Remove both 3 1/2Ó Pulleys (24) and the Cable Trap

(25) from the pre-assembled Pulley Plates (23).

Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)

in the direction shown. Attach the Pulley and the

Cable Trap (25) to the top hole in the Pulley Plates

(23) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon

Locknut (50). Make sure the Cable Trap and Pulley

Plates are oriented as shown in the drawing.

31. Wrap the High Cable (74) around a 3 1/2Ó Pulley (24)

in the direction shown. Attach the Pulley and a Cable

Trap (25) to the 3/8Ó x 4 3/4Ó Bolt (60) that you

attached in step 29. Secure the Pulley with the 3/8Ó

Nylon Jam Nut (63).

32. Wrap the High Cable (74) around a 3 1/2Ó Pulley (24)

in the direction shown. Place two Pulley Covers (47)

over the Pulley so that the slots in the Pulley Covers

are placed over the Cable. Attach the Pulley and the

Pulley Covers to the indicated hole in the Press

Upright (2) with a 3/8Ó x 3 3/4Ó Bolt (59), two 3/8Ó Flat

Washers (48), and a 3/8Ó Nylon Jam Nut (63). Make

sure that the Cable is between the Pulley and the

welded pin on the Upright.

33. Identify the Low Cable (75); it is approximately

404 1/2Ó long and it has a ball on one end and a

closed loop on the other end.

Route the end of the Low Cable (75) with the closed

loop through the cable guide on the Butterfly Base

(4). Next, wrap the Low Cable around a 3 1/2Ó Pulley

(24) in the direction shown. Attach the Pulley and a

Cable Trap (25) to the bracket on the Butterfly Base

with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut

(50).

Cable

Guide

Welded

Bracket