Owner's Manual

17
40. Wrap the Low Cable (75) around a 3 1/2Ó Pulley (24)
in the direction shown. Attach the Pulley to the indi-
cated bracket on the Press Base (6) with a 3/8Ó x
1 3/4Ó Bolt (57) and a 3/8Ó Nylon Locknut (50).
40
6
75
57
50
24
41. Important note: Although the following steps are
not difficult to perform, the correct routing of the
cable is critical. Please make sure that you wrap
the cable around the pulleys exactly as shown in
each step.
Wrap the Low Cable (75) around a 3 1/2Ó Pulley (24)
in the direction shown. Attach the Pulley and a Cable
Trap (25) to the lower hole in the Pulley Plates (23)
with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut
(50). Make sure that the Cable Trap is oriented as
shown.
25
50
23
54
24
75
Bracket
41
42. Wrap the Low Cable (75) around a 3 1/2Ó Pulley (24)
in the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole (make sure that you
choose the upper of the two holes) in the Press
Upright (2) with a 3/8Ó x 3 3/4Ó Bolt (59), a 3/8Ó Flat
Washer (48), and a 3/8Ó Nylon Locknut (50). Make
sure that the Cable Trap is oriented as shown.
25
75
24
2
50
48
59
42