Owner's Manual

7. Place the bracket on the lower end of the Press
Upright (2) over the indicated 5/16Ó x 2 1/2Ó Carriage
Bolts (92) in the Press Base (6). Hand tighten two
5/16Ó Nylon Locknuts (64) onto the Bolts. Do not
tighten the Nylon Locknuts yet.
7
7
6. Slide the bracket on the Butterfly Front Leg (3) onto
the two indicated 5/16Ó x 2 1/2Ó Carriage Bolts (92) in
the Butterfly Base (4). Hand tighten two 5/16Ó Nylon
Locknuts (64) onto the Bolts. Do not tighten the
Nylon Locknuts yet.
Attach the Butterfly Seat Frame (14) to the Butterfly
Front Leg (3) with two 5/16Ó x 2 3/4Ó Bolts (89), two
5/16Ó Washers (36), and two 5/16Ó Nylon Locknuts
(64). Do not tighten the Nylon Locknuts yet.
6
92
6
3
92
14
89
36
64
2
64
64
64
4
8. Place two Weight Bumpers (51) over the indicated
holes in the Weight Base (5). Insert the Weight
Guides (15) into the holes.
Attach each Weight Guide (15) to the Weight Base
(5) with a 3/8Ó x 7Ó Bolt (55), two 3/8Ó Flat Washers
(48), and a 3/8Ó Nylon Locknut (50).
See the inset drawing. Make sure that two Weight
Inserts (96) have been pressed into each Weight
(21). Turn the Weights as shown, with the large pin
groove pointed toward the floor.
Slide all of the included Weights (21) onto the Weight
Guides (15). Make sure that the Weights are
turned as shown, with the pin grooves on the side
shown.
8
51
15
Groove
Pin
Grooves
48
48
55
5
48
96
21
Large Pin
Groove
50