Owner's Manual

11
2. Make sure that the power cord is unplugged.
Have two other persons hold the Uprights (41)
near the brackets on the Base (82) as shown.
Remove the tie securing the upright wire (A).
See the inset drawing. Connect the upright
wire (A) to the base wire (B). The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
2
41
82
B
A
A
B
3. Set the Uprights (41) on the Base (82). Be care-
ful not to pinch the wires (not shown) in the
right Upright.
Attach each Upright (41) with four 3/8" x 1"
Screws (4) and four 3/8" Star Washers (5) (only
one Upright is shown). Start all eight Screws,
and then tighten them.
3
41
4
5
82
4
5