Owner's Manual

10
15. See drawing 15a. Slide the Rear Shroud (15)
under the Top Cover (24).
Attach the Top Cover (24) and the Front and Rear
S
hrouds (14, 15) to the Top Frame (12) with three
M4 x 16mm Self-tapping Screws (99).
See drawing 15b. Attach the Rear Shroud (15) to
the Base (1) with an M4 x 16mm Self-tapping
Screw (99).
18. Attach the Bumper (115) to the Leg Developer (6)
with an M4 x 19mm Self-tapping Screw (100).
Grease an M10 x 75mm Bolt (86). Attach the Leg
Developer (6) to the Seat Frame (4) with the Bolt
and an M10 Nylon Locknut (108).
Do not over
-
tighten the Nylon Locknut; the Leg Developer
must be able to pivot easily
.
17.
Attach the Seat (19) to the Seat Frame (4) with
two M6 x 30mm Screws (87) and an M6 x
100mm Screw (85).
Set the Seat Frame (4) onto a set of posts on the
Upright (3).
16. Attach the Backrest (18) to the Upright (3) with
two M6 x 115mm Screws (113) and two M6
Washers (107).
99
99
12
14
15
24
15a
15b
17
16
18
3
107
107
113
113
19
4
85
87
18
86
Grease
4
108
100
115
6
99
15
1