Owner's Manual

11
20. Attach an Arm Pad (21) and an Arm Pad Base
(22) to the Dip Arm (5) with two M6 x 70mm
Screws (93).
Repeat this step on the other side of the Dip
Arm (5).
22. Attach the Curl Pad (20) to the Curl Post (9) with
two M6 x 30mm Screws (87).
23.
Make sure that all parts are properly tightened
before using the weight system.
The use of the
remaining parts will be explained in the ADJUST-
MENTS section, beginning on the following page.
21. Insert a Pad Tube (17) into the Leg Developer
(6). Slide two Leg Pads (23) and two Pad Covers
(119) onto the Pad Tube.
Slide two Leg Pads (23) and two Pad Covers
(119) onto the Seat Frame (4).
3
3
1
0
3
4
3
5
5
1
102
102
20
21
21
22
93
5
5
6
4
17
23
23
119
119
119
119
23
20
9
87
22
19. Attach a Front and Rear Dip Cap (33, 34) around
a Dip Handle (10) with two M3 x 32mm Self-tap-
p
ing Screws (102).
T
ighten a Dip Arm Knob (51) into the Dip Arm (5).
Pull the Knob out as far as it will go and insert the
Dip Handle (10) through a Dip Arm Bushing (35)
and into the Dip Arm. Engage the Knob into the
Dip Handle.
Repeat this step on the other side of the Dip
Arm (5).
1
9