Owner's Manual

15
28
27
78
77
36
48
66
48
43
47
16
96
108
76
Lever
MOVING THE WEIGHT SYSTEM
T
o move the weight system, step on the levers on the
Locking Casters (76) to unlock the wheels. Move the
w
eight system to the new location. Relock the wheels
on the Locking Casters.
CHANGING THE WEIGHT SETTING
To change the setting of the weight stack, insert the
Weight Pin (28) under the desired Weight (27). Insert
the Weight Pin so that the bent end touches the
weight stack. Turn the bent end down.
Note: Due to the cables and pulleys, the amount
of resistance at each exercise station may vary
from the weight setting. Use the WEIGHT
RESISTANCE CHART on page 16 to find the
approximate amount of resistance.
LOCKING THE WEIGHT STACK
To lock the weight stack, insert the Lock Pin (78) into
the indicated hole in a Weight Guide With Hole (36).
Insert the Lock (77) through the hole in the Weight
Pin and close the Lock.
ADJUSTING THE CABLE
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cable before resistance is felt, the
cables should be tightened.
T
o tighten the cable, remove the M10 x 50mm Bolt
(96) from the Weight T
ube (16). Reattach the 3 1/2"
Pulley (43), the Cable Trap (47), and the two Finger
Guards (48) to a lower hole in the Weight Tube with
the Bolt and an M10 Nylon Locknut (108).
Make sure
that the Cable Trap is oriented to hold the Press
Arm Cable (66) in the groove of the Pulley. To
loosen the Cable, attach the Pulley to a higher hole in
the Weight Tube.