User's Manual

1. Make sure that the power cord is unplugged. Remove

the indicated Screws from the Console Back (A).

Important: The Screws may be different lengths. Keep

track of which Screws were removed from which holes.

2. Peel the paper off the pad on the bottom of the Receiver

(B). Turn the Receiver so the cylinder is on the side

shown, and press the Receiver into the bottom of the

Console Base (D) in the indicated location.

Screws

Cylinder

3. Connect the included Short Jumper Wire (E) to the wire

on the Receiver (B). Connect the other end of the Short

Jumper Wire to the PLS2 jack on the back of the Console

(C). If there is a wire already plugged into the PLS2 jack,

unplug it. Note: The other wires included with the receiver

may be discarded. The Wire Tie can be used to tie wires,

if needed.

Make sure that no wires are pinched. See step 1.

Reattach the Console (C) with the Screws. Important: If

the Screws are not put back into the same holes from

which they were removed, the Console will be dam-

aged.

PLS2

Jack