User's Manual

1. Make sure that the power cord is unplugged. Remove

the indicated Screws (A) from the Console Back (B).

Remove the Console Back from the Console Base (C).

2. Connect the included Long Jumper Wire (D) to the wire on

the Receiver (E). Feed the Long Jumper Wire through the

Console (F) as shown. Connect the other end of the Long

Jumper Wire to the PULSE jack on the back of the

Console. If there is a wire already plugged into the PULSE

jack, unplug it. Turn the Receiver so the cylinder is on

the side shown, and press the Receiver onto the back of

the Console Base (C) in the indicated location. Note: The

other wires included with the receiver may be discarded.

The Wire Tie can be used to tie wires, if needed.

Make sure that no wires are pinched. See step 1.

Reattach the Console Back (B).

PULSE

Jack

Cylinder

1. Make sure that the power cord is unplugged. Remove

the indicated Screw (A) and the Pulse Door (B).

2. Connect the Pulse Wire (C) to the wire on the Receiver (D).

Note: The wires included with the receiver may be dis-

carded. The Wire Tie can be used to tie wires, if needed.

Turn the Receiver (D) so the cylinder is on the side

shown, and hold the Receiver inside of the hole in the

back of the Console Base (E). Attach the Receiver with the

two Small Screws (F) included with the receiver.

Make sure that no wires are pinched. See step 1.

Reattach the Pulse Door (B) with the Screw (A).

Cylinder