User's Manual

8
Key
Pulse Sensor
Clip
BATTERY INSTALLATION
The console re-
quires two "1,5V"
batteries (in-
cluded). Alkaline
batteries are rec-
ommended. To in-
stall batteries, open
the battery cover
under the console
as shown. Press
two batteries into the battery compartment. Make sure
that the negative (–) ends of the batteries are
touching the springs. Close the battery cover.
STEP-BY-STEP CONSOLE OPERATION
If there is a thin sheet of clear film on the face of the
console, remove it.
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Note: The console can display distance and speed in
either kilometres or miles. (See HOW TO SELECT
KILOMETRES OR MILES on page 9.)
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps below to operate the console.
Insert the key into the power switch.
Inserting the key will not
turn on the displays.
The displays will turn on
when the On/Reset but-
ton is pressed or when
the walking belt is
started. Note: If you just
installed batteries, the displays will already be on.
Reset the speed control.
Slide the speed control to the RESET position.
Note: Each time the walking belt is stopped,
the speed control must be moved to the
RESET position before the walking belt can be
restarted.
2
1
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing above)
while operating the treadmill. When the key
is removed from the console, the walking
belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable water
bottle.
Batteries
Battery
Cover
On/Reset Button
Display Button
Speed Control
Monitor Display
Pulse Display