User's Manual

8
6. While a second person holds the console as-
sembly near the Left Handrail (103), attach the
ground wire to the indicated hole in the Left
Handrail with a 1/2" Screw (33).
103
Hole
Ground
Wire
Console
Assembly
33
6
7. While the second person continues to hold the
console assembly, locate the console wire har-
ness on the back of the console assembly.
Connect the console wire harness to the Upright
Wire Harness (77).
Make sure to connect the
connectors properly (see the inset drawing).
The connectors should slide together easily
and snap into place. If the connectors do not
slide together easily and snap into place, turn
one connector and then try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
Then, insert the connectors down into the Right
Handrail (104).
77
Console
Assembly
77
104
7
Console Wire
Harness
5. Attach the lower ends of the Handrails (103,
1
04) to the Uprights (84) with two Long Handrail
Bolts (106) and two Star Washers (8);
start both
Handrail Bolts and then firmly tighten them.
F
irmly tighten the four Handrail Bolts (64) (only
two are shown)
.
See step 3. Firmly tighten the four Screws (3).
106
64
103
104
106
8
8
8
4
5
84