User's Manual

14
Heart Rate display—
This display shows
your heart rate when
you use the handgrip
pulse sensor or the
optional chest pulse
sensor.
Speed display—This
display shows the
speed of the walking
belt. Note: When the
Metric indicator beside
the display is lit, the
console will display speed and distance in kilome-
tres; when the Metric indicator is not lit, the con-
sole will display speed and distance in miles. To
change the unit of measurement, see THE IN-
FORMATION MODE/DEMO MODE on page 24.
Calories/Distance dis-
play—This display
shows the approximate
number of calories you
have burned and the
distance that you have
walked or run. The display will change from one
number to the other every few seconds, as shown
by the indicators beside the display.
Pace/Time display—
Whilst the manual
mode or the iFIT.com
mode is selected, this
display will show your
pace (in minutes per
mile) and the elapsed time. Whilst a program is se-
lected (except for the heart rate Self Select pro-
gram), the display will show your pace and the
time remaining in the program. The display will
change from one number to the other every few
seconds, as shown by the indicators beside the
display.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
Measure your heart rate if desired.
To use the hand-
grip pulse sen-
sor, first make
sure that your
hands are clean.
Next, stand on
the foot rails
and hold the
handgrip pulse
sensor with your palms on the metal contacts.
Avoid moving your hands. When your pulse is
detected, two dashes (– –) will appear in the Heart
Rate display, and then your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
Turn on the fan if desired.
To turn on the fan, press the button below the fan.
To turn on the fan at high speed, press the button
a second time. To turn off the fan, press the but-
ton a third time. Note: A few minutes after the
walking belt is stopped, the fan will automatically
turn off.
When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will be damaged. Next, re-
move the key from the console and put it in a se-
cure place. Note: If the displays and various indi-
cators on the console remain lit after the key is
removed, the console is in the “demo” mode.
See page 24 and turn off the demo mode.
When you are finished using the treadmill, move
the on/off switch near the power cord to the off
position and unplug the power cord.
8
7
6
Contacts