User's Manual

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet. (See page 11.) If an ex-

tension cord is needed, use only a 3-conductor, 1 mm

(14-gauge) cord that is no longer than 1.5

m (5 ft.). Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

near the power cord. If the switch protrudes as

shown, the circuit breaker has tripped. To reset the

circuit breaker, wait for five minutes and then press

the switch back in.

d. Check the on/off switch located on the treadmill

near the power cord. The switch must be in the on

position.

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the

circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If it is plugged in, unplug it, wait for five minutes, and

then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. Make sure that the on/off switch is in the on position.

e. If the treadmill still will not run, please call our Customer Service Department.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. If an extension cord is needed, use only a 3-conductor, 1mm

(14-gauge) cord that is no longer

than 1.5 m (5 ft.).

b. If the walking belt is overtightened, treadmill performance

may decrease and the walking belt may be permanently

damaged. Remove the key and UNPLUG THE POWER

CORD. Using the included allen wrench, turn both rear

roller adjustment bolts counterclockwise 1/4 of a turn.

When the walking belt is properly tightened, you should

be able to lift the edges of the walking belt 5–7 cm (2–3

in.) off the walking platform. Be careful to keep the walk-

ing belt centred. Plug in the power cord, insert the key

and run the treadmill for a few minutes. Repeat until the

walking belt is properly tightened.

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and

follow the steps listed. If further assistance is needed, please call our Customer Service Department.

Rear Roller Adjustment Bolts

5–7cm

Tripped

Reset

Position