User's Manual

4. With the help of a second person, hold the con-

sole assembly near the Uprights (73, 74).

Connect the Upright Wire Harness (75) to the

onsole Wire Harness (71). M

ake sure to con-

nect the connectors properly (see the inset

drawing). The connectors should slide to-

gether easily and snap into place.

If they do

not, turn one connector and try again. IF THE

CONNECTORS ARE NOT CONNECTED

PROPERLY, THE CONSOLE MAY BE DAM-

AGED WHEN THE POWER IS TURNED ON.

Console

Assembly

5. Insert the brackets on the Handrails (99) into the

Right Upright (74) and the Left Upright (73).

Make sure that no wires are pinched.

Finger

tighten three Handrail Bolts (64) with

three Star Washers (90) into the Right Upright

(74). Next, finger tighten three Handrail Bolts

with three Star Washers (not shown) into the

Left Upright (73). Then, firmly tighten all six

Handrail Bolts.