User's Manual

7. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is

used to adjust the walking belt (see page 28).

. Place the treadmill in the storage position (see HOW TO

FOLD AND MOVE THE TREADMILL on page 25).

Next, place the cylinder end of the Shock (108) near the

racket on the base of the Uprights (84).

See the two small inset drawings. Using your fingernail

or the end of a screwdriver, press on the end of the

Shock Pin (112) to loosen it from the Shock (108). Next,

rotate the Shock Pin and pull it out of the Shock.

careful to avoid losing the Shock Pin.

See drawing 5a. Press the cylinder end of the Shock

(108) onto the ball on the bracket. Next, insert the end of

the Shock Pin (112) through two of the small holes in the

end of the Shock. Then, rotate the Shock Pin until it clips

onto the Shock.

108

112

108

112

Bracket

Raise the Shock (108) to a vertical position. Remove the

Shock Pin (112) from the raised end of the Shock as de-

scribed in step 5. If necessary, rotate the Shock to align

the end of the Shock with the ball on the bracket on the

Frame (58).

Next, press the Incline increase and decrease buttons

until the ball on the bracket is aligned with end of the

Shock (108). Then, press the end of the Shock onto the

ball. Note: It may be necessary to press the end of the

Shock onto the ball whilst the Frame is moving.

See drawing 6a. Insert the Shock Pin (112) into the two

indicated small holes in the end of the Shock (108).

Then, rotate the Shock Pin until it clips onto the Shock.

Note: Extra Shock Pins are included.

Press the Incline decrease button until the treadmill is at

the lowest incline level. Then, unplug the power cord.

112

108

Holes

112

108

Bracket

112