User Manual

ASSEMBLY

• To hire a service technician to assemble this

product in your home, call 1-800-445-2480.

• Assembly requires two persons.

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing

materials until you nish assembly.

• The underside of the walking belt is coated with

high-performance lubricant. After shipping, there

may be some lubricant on top of the walking belt

or on the shipping carton. This is normal. If there

is lubricant on top of the walking belt, wipe it off

with a soft cloth and a mild, non-abrasive cleaner.

• To identify small parts, see page 6.

• Assembly requires the following tools:

the included hex keys

one adjustable wrench

one Phillips screwdriver

scissors

needlenose pliers

To avoid damaging parts, do not use power tools

for assembly.

1. Make sure that the power cord is unplugged.

Place a piece of cardboard below the rear of the

Frame (56) to protect the oor or carpet.

Attach the Left Wheel Cap (96) to the Base (94)

with two #8 x 3/4" Screws (2).

Attach the Right Wheel Cap (not shown) to

the right side of the Base (94) in the same

way.

Cardboard

2. Pull the Upright Wire (81) and the Base Ground

Wire (110) through the indicated hole in the

Base (94).

Attach the Base Ground Wire (110) to the Base

(94) with a #8 x 1/2" Ground Screw (10).

Press the Grommet (77) into the square hole in

the Base (94).

Hole

110