User's Manual

9
6
17
17
7
2
7
5
14
33
40
20
36
7
6. Using a plastic bag to keep your fingers clean,
apply a generous amount of the included grease
to an M10 x 75mm Bolt (32).
Attach the Leg Lever (4) to the Front Leg (8) with
the M10 x 75mm Bolt (32) and an M10 Locknut
(33). Do not overtighten the Locknut; the Leg
Lever must pivot easily.
Grease
8
43
28
5
4
33
32
8
8. Apply a small amount of the included grease to
an M12 x 90mm Bolt (40).
Insert the Pivot Bracket (7) into the Seat Frame
(2), and attach the Backrest Frame (5) to the
Seat Frame with the M12 x 90mm Bolt (40) and
an M12 Locknut (20). Do not overtighten the
Locknut; the Backrest Frame must pivot
easily.
Next, insert the Lock Pin (36) through the Seat
Frame (2) and through one of the adjustment
holes in the Pivot Bracket (7).
Then, attach an M10 x 20mm Bolt (14) and an
M10 Locknut (33) to the Pivot Bracket (7).
See step 7. Tighten the M8 Locknuts (17).
7. Orient the Backrest Frame (5) as shown. Make
sure that there is a Bushing (28) in each side
of the Backrest Frame. If necessary, press a
Bushing into each side of the Backrest Frame.
Then, attach the Pivot Bracket (7) to the
Backrest Frame (5) with two M8 x 80mm Bolts
(43) and two M8 Locknuts (17); do not tighten
the Locknuts yet.
Grease