User's Manual

M10 x 55mm Screw (16)

M10 Nylon

Locknut (24)

M6 Washer (23)

M6 x 60mm Screw (19)

M10 x 256mm Bolt (17)

M10 x 45mm Screw (18)

M6 x 25mm

Screw (20)

M10 Washer (22)

M5 x 15mm

Screw (21)

PART IDENTIFICATION CHART

See the drawings below to identify small parts used in assembly. The number in parentheses by each drawing is

the key number of the part, from the PART LIST on page 10. Note: Some small parts may have been pre-

assembled. If a part is not in the parts bag, check to see if it has been preassembled.

To hire an authorized service technician to

assemble the weight bench, call toll-free

1-800-445-2480.

Before beginning assembly, carefully read the

following information and instructions:

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing

materials until assembly is completed.

• Tighten all parts as you assemble them, unless

instructed to do otherwise.

• As you assemble the weight bench, make sure all

parts are oriented as shown in the drawings.

• Assembly requires two persons.

• For help identifying small parts, use the PART

IDENTIFICATION CHART above.

In addition to the included grease packet,

assembly may require the following tools:

• one standard screwdriver

• one Phillips screwdriver

• one adjustable wrench

• one rubber mallet

ASSEMBLY