Instructions / Assembly

26
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
The console requires activation. If you have not
activated the console, see assembly step 17 on
page 15.
Most console problems are the result of low batteries.
To replace the batteries, see assembly step 14 on
page 13.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 20.
HOW TO LEVEL THE ELLIPTICAL
If the elliptical rocks slightly on your floor during use,
see HOW TO LEVEL THE ELLIPTICAL on page 16.
HOW TO GREASE THE ROLLERS
If the Rollers (16)
squeak when
moving on the
Track (11), apply
a small amount of
the included PTFE
grease to a paper
towel. Spread a
thin layer of grease
evenly along the
Track where the Rollers move. Then, wipe off any
excess grease.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed
switch, first use a
standard screw-
driver and carefully
pry the Accessory
Tray (50) upward off
the Right and Left
Shields (48, 49).
Next, locate the Reed Switch (33). Turn the Pulley (15)
until a Magnet (65) is aligned with the Reed Switch.
Next, slightly loosen the indicated M4 x 16mm Screw
(56). Slide the Reed Switch (33) slightly closer to or
away from the Magnet (65), and then retighten the
Screw. Then, rock the Pulley (15) forward and back-
ward just enough that the Magnet passes the Reed
Switch repeatedly.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the accessory tray.
16
Grease
11
50
48
49
56
65
33
15
MAINTENANCE AND TROUBLESHOOTING