Instructions / Assembly

15
18. Lift the latch on the underside of the Right Pedal
Arm (14), and set the Right Pedal Arm on the
right Crank Bushing Sleeve (43).
Release the lever, and make sure that the Right
Pedal Arm (14) is securely connected to the
Crank Bushing Sleeve (43).
Connect the Left Pedal Arm (not shown) in
the same way.
See step 6. Tighten the M8 x 69mm Bolt (80)
and the two M8 x 23mm Screws (84).
Latch
43
14
18
5
60
19
19. See the upper and lower drawings. Plug
the Power Adapter (60) into the receptacle
inside the indicated battery compartment on
the Console (5), and route the power adapter
through the notch in the battery cover.
Note: To plug the Power Adapter (60) into an
outlet, see HOW TO PLUG IN THE POWER
ADAPTER on page 16.
See the lower drawing. The Console (5) can
also be operated with four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batteries
together.
Remove the screws, remove the battery covers
from the back of the Console (5), and insert bat-
teries into the battery compartments, and then
reattach the battery covers. Make sure to ori-
ent the batteries as shown by the diagrams
inside the battery compartments.
5
Screws
Battery
Covers
Receptacle
Notch
Receptacle
20. Make sure that all parts of the elliptical are properly tightened. Extra parts may be included. To protect
the floor or carpet from damage, place a mat under the elliptical.