Instructions / Assembly

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while the

resistance is adjusted to the highest setting, the drive

belt may need to be adjusted. To adjust the drive belt,

first unplug the power adapter.

See EXPLODED DRAWING B on page 26. First,

remove the M4 x 16mm Screw (61) from the Left Leg

Inner Cover (39). Then, remove the Left Leg Inner

Cover and the Left Leg Outer Cover (92).

Next, remove the two M8 x 16mm Screws (76) and the

two M8 Washers (33) from the Left Upper Body Leg

(101) and the Left Pedal Arm (14).

Then, remove

the M8 x 14mm

Shoulder Screw

(81) from the Left

Pedal Arm (14).

Remove the Left

Pedal Arm from

the elliptical.

Remove the four M4 x 16mm Screws (not shown)

from the Large Storage Foot (27), and then remove

the Large Storage Foot. Remove the two M4 x 16mm

Screws (not shown) from the Top Shield (37), and

then use a standard screwdriver to pry the Top Shield

upward off the elliptical. Then, pry the left Pedal Disc

(26) off the elliptical.

See EXPLODED DRAWING C on page 27. Identify

the Left and Right Shields (44, 45). Remove all of the

M4 x 16mm Screws (61) and 3/16" x 1 3/8" Screws

(64) from the Left and Right Shields. Make sure to

note which size Screws come from which holes.

Then, carefully remove the Left Shield.

Loosen the Idler Screw (97). Tighten the Idler

Adjustment Screw (72) until the Drive Belt (46) is tight.

When the Drive Belt is tight, retighten the Idler Screw.

When you are finished, reattach the parts that you

removed. Then, plug in the power adapter.