Use and Care Manual

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is adjusted to the highest

level, the drive belt may need to be adjusted.

To adjust the drive belt, first remove the M4 x 19mm

Self-tapping Screw (100) from the Side Access Cover

(21), and then remove the Side Access Cover by

moving it in the direction shown by the arrow.

Next, loosen the M10 x 55mm Bolt (99). Then, tighten

the M8 Locknut (68) until the Drive Belt (64) is tight.

When the Drive Belt (64) is tight, tighten the

M10 x 55mm Bolt (99). Then, reattach the side access

cover.

100