Manual

7, 7
identifytheLeftHandlebar(9),whichismarkedwitha
sticker,inserttheLeftHandiebarintooneofthe
HandHebarLegs(79);makesurethatthe Handlebar
Legis turnedsothe hexagonaJholesareonthe
indicatedside,AttachtheLeftHandiebarwithtwoM8
x 43mmButtonBolts(50)andtwoM8NylonLocknuts
(46),Donot tightenthe ButtonBoltsyet.Make
surethattheNylonLocknutsareseatedin the
he×agonaihoJes.
Attachthe RightHandlebar(notshown}tothe
otherHandlebarLeg (not shown} in the same way.
Apply a generous amount of grease to the Pivot Axle
(108) and to the two M8,5 Smali Washers (53), insert
the Pivot Axle into the Upright (2) and center it, Reapply
grease to both sides of the Pivot Axle,
identify the Left and Right Handiebars (9, 10), which
are marked with stickers, SHde a Handiebar Spacer
(25) onto the short tube on each Handiebar, and siide
the Handiebars onto the Pivot Axie (108), Make sure
that the Handlebars are on the correct sides.
Orient the two Handlebar Caps (23) as shown, and
press the small tabs on the Handlebar Caps into the
two Handlebar Spacers (25), Tighten an M8 x 19mm
Shoulder Screw (22) with an M8,5 Small Washer (53)
into each end of the Pivot Axle (108),
Remove the Chrome Tube (118) from the left
Handlebar Leg (79), Apply a small amount of the
included Teflon _ lubricant to a paper towel, and rub a
thin film of lubricant onto the Chrome Tube, Then, rein°
sert the Chrome Tube into the Handlebar Leg,
See the drawing at the right and the inset drawing,
Apply a thin film of grease to the shaft of a Union Bolt
Set (27), insert the shaft of the Union Bolt Set into the
side of the left Flex Bar (14) closest to the Upright (2),
and then slide a 4,7mm Spacer (143) onto the shaft,
Next, slide the end of the left Chrome Tube (118) onto
the shaft and onto the Spacer. Then, slide a Wheel
Bushing (28), a Ramp Wheel (119), and another
Wheel Bushing onto the shaft, Make sure that aH
parts are oriented exactly as shown, insert the shaft
completely through the Flex Bar and tighten the screw
of the Union Bolt Set into the shaft,
Repeat this step to attach the right Chrome Tube (118)
to the right Flex Bar (14),
53
t i
t i
9%
_" 46
Jr Hobs
J f
J f
I
79 j_
J f
J f
9 Tube
/
23
f
Lubricate
53
22
14
8