User's Manual

11
8
14
139
139
140
140
140
62
12
8. Identify the Right Pedal (14) and the Right Pedal
Arm (12) and orient them as shown.
Attach the Right Pedal (14) to the Right Pedal
Arm (12) with four M6 x 12mm Screws (139) and
four M6 x 13mm Washers (140); do not tighten
the Screws yet.
Next, tighten an M6 x 50mm Screw (62) with
an M6 x 13mm Washer (140) into the Right
Pedal Arm (12) and the Right Pedal (14). Then,
tighten the four M6 x 12mm Screws (139).
Attach the Left Pedal (not shown) to the Left
Pedal Arm (not shown) assembly in the same
way.
7
7. Using a small plastic bag to keep your fingers
clean, apply a generous amount of the included
grease to the Upright Axle (48) and to two M17 x
27mm Wave Washers (88).
Tip: Avoid damaging the Upright Wire (60).
Insert the Upright Axle (48) through the Upright
(5) and center it. Slide an M17 x 27mm Wave
Washer (88) onto each side of the Upright Axle.
Slide the Right and Left Upper Body Arms
(8, 9) onto the right and left sides of the Upright
Axle (48).
Tighten an M8 x 16mm Screw (102) and an M8
x 25mm x 1.5mm Washer (126) into each end of
the Upright Axle (48) at the same time.
9
126
126
8
5
102
102
48
Grease
60
88
88
Avoid damaging the
Upright Wire (60)