User's Manual

ManualsBrandsProForm ManualsFitness EquipmentProForm PFEL180122 - 14.0 RE ELLIPTICAL

MAINTENANCE

Inspect and tighten all parts of the elliptical regularly.

Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damage

to the console, keep liquids away from the console

and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the

power cord is fully plugged in. If lines appear in the

console display, see HOW TO CHANGE CONSOLE

SETTINGS on page 29 and adjust the contrast level

of the display.

If the console does not display your heart rate when

you hold the handgrip heart rate monitor, or if the dis-

played heart rate appears to be too high or too low, see

step 5 on page 24.

HOW TO GREASE THE ROLLERS

See the EXPLODED DRAWING near the end of this

manual. If the Ramp Rollers (92) squeak when mov-

ing on the Ramp (43), apply a small amount of the

included PTFE grease to a paper towel. Spread a thin

layer of grease evenly along the tracks on the Ramp.

Then, wipe off any excess grease.

HOW TO CALIBRATE THE INCLINE SYSTEM

If the ramp is not functioning properly, the incline sys-

tem may need to be calibrated. To calibrate the incline

system, press and hold the Calorie button for several

seconds until the test mode appears in the display.

Press the Calorie button again. Press the Quick Ramp

increase or decrease button to calibrate the incline

system. The ramp will move upward and downward as

the incline system calibrates.

When the ramp stops moving, the incline system is

calibrated. Then, press the Calorie button repeatedly

to exit the test mode.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the

reed switch,

first unplug the

power cord.

Using a flat

screwdriver,

release the tabs

on the Top Shield

(20) and pry

the Top Shield

upward off the

elliptical.

Next, look into the access opening and locate the

Reed Switch (69). Rotate the Large Pulley (74) until a

Magnet (75) is aligned with the Reed Switch.

Next, loosen, but do not remove, the indicated M4 x

16mm Screw (93). Slide the Reed Switch (69) slightly

toward or away from the Magnet (75). Then, retighten

the M4 x 16mm Screw.

Plug in the power cord and rotate the large pulley for

a moment. Repeat these actions until the console

displays correct feedback. When the reed switch is

correctly adjusted, reattach the access cover.

MAINTENANCE AND TROUBLESHOOTING