User's Manual

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is adjusted to the highest

level, the drive belt may need to be adjusted.

To adjust the drive belt, first unplug the power cord.

Using a flat screwdriver, release the tabs on the Top

Cover (20) and pry the Top Shield upward off the

elliptical.

Next, lift the Latch (117) on the underside of the Left

Pedal Arm (13), and then lift the Left Pedal Arm off the

left Sleeve (136).

See EXPLODED DRAWING B on page 37. Remove

the M4 x 16mm Screws (93) and the M4 x 42mm

Screws (124) from the Right and Left Shields (18, 19).

Make sure to note which size Screws come from

which holes. Then, carefully remove the Left Shield.

Loosen the Pivot Screw (97). Tighten the Belt

Adjustment Screw (85) until the Drive Belt (38) is tight.

When the Drive Belt is tight, tighten the Pivot Screw.

When you are finished, reattach the left shield, replace

the left pedal arm, and reattach the access cover.

Then, plug in the power cord.

117

19, 18

124

136