User's Manual

ManualsBrandsProForm ManualsFitness EquipmentProForm PFEL559140 - ENDURANCE 520 E ELLIPTICAL

MAINTENANCE

Inspect and tighten all parts of the elliptical regularly.

Replace any worn parts immediately.

To c l ean the e llip tica l , u s e a damp clot h an d a s mall

amount of mild soap. IMPORTANT: To avoid damage

to the console, keep liquids away from the console

and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not display your heart rate when

you hold the handgrip heart rate monitor, or if the dis-

played heart rate appears to be too high or too low, see

step 5 on page 22.

HOW TO LEVEL THE ELLIPTICAL

If the elliptical rocks slightly on your floor during use,

see HOW TO LEVEL THE ELLIPTICAL on page 18.

HOW TO GREASE THE ROLLERS

See the EXPLODED DRAWING near the end of this

manual. If the Rollers (51) squeak when moving on

the Tracks (16), ﬁ rst clean the Tracks and the Large

Rollers with a lint-free cloth and rubbing alcohol. Next,

apply one packet (3 grams) of the included PTFE

grease to each Track. Use a lint-free cloth or your

ﬁ ngers to spread the grease evenly along the Tracks.

Then, wipe off any excess grease. If the included

grease packets have been used or lost, use a high-

quality clear or white grease instead.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the drive

belt, first unplug the power adapter.

See EXPLODED DRAWING C on page 39. Using a

standard screwdriver, remove the left Disc (71).

Note: For clarity, the left shield is shown removed in the

drawing below.

Next, locate the Reed Switch (38). Turn the Pulley (19)

until a Magnet (43) is aligned with the Reed Switch.

Loosen, but do not remove, the indicated M4 x 16mm

Screw (101). Slide the Reed Switch (38) slightly closer

to or away from the Magnet (43), and then retighten

the Screw.

Then, unplug the power adapter and rock the Pulley

(19) forward and backward just enough that the

Magnet (43) passes the Reed Switch (38) repeatedly.

Repeat these actions until the console displays correct

feedback.

When the reed switch is correctly adjusted, reattach

the left disc and plug in the power adapter.

MAINTENANCE AND TROUBLESHOOTING

101