User's Manual

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest level, the drive

belt may need to be adjusted.

To adjust the drive belt, first unplug the power

adapter.

See assembly step 16 on page 15. Use a standard

screwdriver to remove the Shield Cover (75) and the

Shield Cover Cap (118).

Next, see assembly step 15 on page 15 and remove

the Right Upper Body Leg Outer and Inner Covers (69,

83).

Then, see assembly step 12 on page 13 and remove

the Right Pedal Arm (58) from the Right Upper Body

Leg (60).

See EXPLODED DRAWING B on page 38 and

EXPLODED DRAWING A on page 37. Remove the

Right Roller Arm (59) from the right Crank Arm (20).

Then, carefully remove the Right Roller Arm assembly

from the elliptical.

See EXPLODED DRAWING C on page 39. Remove

the M4 x 19mm Screws (5) and the M4 x 48mm Screw

(107) from the Left and Right Shields (73, 74). Then,

remove the Right Shield.

Next, locate and loosen the Idler Screw (89). Next,

tighten the Belt Adjustment Screw (91) until the Drive

Belt (113) is tight. Then, retighten the Idler Screw.

Reattach the right shield, the right roller arm, the right

pedal arm, the shield cover cap, and the shield cover.

Then, plug in the power adapter.

113