User's Manual

5
M6 x 16mm Patch
Screw (96)–4
M8 Washer
(80)–2
M6 Large
Washer (87)–4
M4 x 19mm
Self-tapping
Screw (95)–6
M4 x 25mm
Self-tapping
Screw (92)–2
M8 x 45mm Button
Bolt (71)–4
M8 x 70mm Button
Bolt (66)–2
M8 Small
Washer (88)–2
M10 x 75mm Carriage
Bolt (65)–4
M8 x 25mm Patch
Screw (83)–4
M4 x 16mm
Screw (84)–4
M8 Locknut
(79)–6
M10 Locknut
(77)–4
23mm x 19.5mm
Wave Washer (49)–2
22mm x 16.5mm
Wave Washer (70)–6
Crank Arm Spacer (25)–2
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
A
ssembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled.
If a part is not in the hardware kit, check to see if it has been preassembled.