User's Manual

9
8
9. Make sure all parts are properly tightened before you use the weight bench. The use of the remaining parts
will be explained in ADJUSTMENT, beginning on the next page.
7
2
9
15
6
1
30
2
3
30
7. Insert the Backrest Bracket (8) into the slot in
the Frame (1) as shown. Next, grease an M10 x
1
80mm Bolt (23). Then, attach the Seat Frame
(6) and the Backrest Tubes (9) to the Frame (1)
w
ith the Bolt, two M10 Washers (30), and an
M10 Nylon Locknut (2). Do not overtighten the
Nylon Locknut; the Seat Bracket and
Backrest Tubes must pivot easily.
Engage the Adjustment Knob into the Backrest
Bracket. Then, tighten the Adjustment Knob (15)
into the Frame (1).
See step 4 and tighten the M8 Nylon
Locknuts (29). See step 5 and tighten the M6
x 60mm Screws (24).
Grease
Slot
8. Attach the Seat Pin (14) to the Seat Frame (6)
with an M4 x 15mm Screw (20).
Insert the Seat Pin (14) into a hole in the Seat
Frame (6) and the Frame (1). Note: For clarity,
the seat is not shown in this step.
20
1
14
6
8